Die Protection - SmartPAC 2 - WaveformPAC
SmartPAC 2 - WaveformPAC Tonnage Waveform Monitoring
WaveFormPAC monitors the tonnage waveform profiles during each press stroke and stops the press if variations exceed preset limits.
- Verify setups
- Check tool timing
- Monitor snap-through load
- Diagnose tooling problems
- Separately monitor clamping and forming forces
- Verify part quality
- Analyze draw speed
- For press speeds up to 250 strokes per minute
For the ultimate in on-the-spot setup verification, the WaveFormPAC allows you to store a benchmark waveform for each die, and compare it to the current signature right on the SmartPAC 2's screen!
To ensure that you're not exceeding the off-bottom load capabilities of your press, the WaveFormPAC allows you to do an on-screen comparison of your actual tonnage signature against the maximum tonnage curve for the press.