WaveFormPAC monitors the tonnage waveform
profiles during each press stroke and stops the
press if variations exceed preset limits.
Verify setups
Check tool timing
Monitor snap-through load
Diagnose tooling problems
Separately monitor clamping and forming
forces
Verify part quality
Analyze draw speed
For press speeds up to 250 strokes per
minute
For the ultimate in on-the-spot setup
verification, the WaveFormPAC allows you to
store a benchmark waveform for each die, and
compare it to the current signature right on the
SmartPAC 2's screen!
To ensure that you're not exceeding the
off-bottom load capabilities of your press, the
WaveFormPAC allows you to do an on-screen
comparison of your actual tonnage signature
against the maximum tonnage curve for the
press.
