3 Methods to Apply Lubricant to Incoming Stock This extremely versatile system has the ability to regulate and apply an oil film on the top surface only, the bottom surface only, or both sides of incoming stock material without mess and waste. The controlled flow of lubricant reduces die wear and flushes foreign material from stock. No Waste, No Mess Four rollers squeeze off excess oil which is drained and filtered into a storage tank to be recycled and used again. A sight gauge, low-level warning indicator assures a continuous flow of lubricant. The pump can handle stamping oils, as well as water soluble oils. Rubber rolls can be supplied for special finish materials in place of the standard steel rolls. Clean Up your Press Area By installing a "Slim Line" gravity fed stock oiler. Improve die life by applying the right amount of oil just before the material enters the die set. The head assembly is compact and allows mounting very close to the tool. Oil flow is delivered to predrilled manifolds with extra absorbent felt roller washers providing a uniform film onto the coil stock. A Durable Storage Tank Mounts to the side of the press and is equipped with a liquid sight gauge. The overflow return line handles excess oil which is then reusable.
Clean Up your Press Area By installing a "Slim Line" gravity fed stock oiler. Improve die life by applying the right amount of oil just before the material enters the die set. The head assembly is compact and allows mounting very close to the tool. Oil flow is delivered to predrilled manifolds with extra absorbent felt roller washers providing a uniform film onto the coil stock. A Durable Storage Tank Mounts to the side of the press and is equipped with a liquid sight gauge. The overflow return line handles excess oil which is then reusable.
